The Best Home Improvement Ideas > Kitchen > Kitchen Sink Faucet Not Working

Kitchen Sink Faucet Not Working



Kitchen Sink Faucet Not Working
The diverter inside your kitchen faucet redirects the water from the faucet spout to your faucet sprayer when you press the sprayer trigger. When you squeeze the trigger, the water pressure drops to engage the diverter. This stops the water flow at the spout and moves it to the sprayer. If your kitchen sprayer quits working, …
If that’s not the problem, your kitchen faucet either has a clogged aerator on the faucet’s tip or it has a clogged cartridge. Both are easy to repair, and you don’t need … 2. Lay a towel on the countertop. Put the sink’s drainer in place in the sink so none of the aerator parts can go down the drain as you clean and rinse them.
bad diverta on old kitchen faucet ,removed diverta to get some more life out of faucet,it will work fine with …
Quick answer: Shut-off valve inside of my quick release attachment under sink. This little valve became loose …
this is what I went through to figure out why no water was coming out of my faucet and what I did to fix it.
Jul 29, 2010 – Similar problem: All other water faucets work fine, so I took off the kitchen sink aerator to figure out what it was. Water flowed out the sink without the aerator on, then I felt like an idiot, because the aerator was equipped with a separate on/off lever. Saved myself some embarrassment in front of a plumber.
Jan 26, 2008 – Re: water stopped running in kitchen faucet. Lisa,. Don’t condemn the whole kitchen faucet yet. First, did you check to see if the aerator is clogged with debris?? The aerator is the little screw-on connection at the spout. First, stuff a rag or scrunched up paper toweling in the sink drain hole so no small parts …
Nov 30, 2013 – There is no trickle, it just doesn’t work. I turned to shut-off valves on and off completely but nothing happened. It’s a single handle faucet with a built in sprayer. I took off the handle and also looked under the sink to see if there is anything obviously wrong or broken but either there isn’t or I don’t understand …
Chances are either the valve seal has disintegrated and clogged the line, or other sediment has broken free and done the same. Disassembling a faucet is usually fairly simple. Remove the set screw retaining the handle, then start removing the exposed nut, washers, and valve components. Lay them out in order for correct …
Aug 11, 2009 – Be sure to turn off the shut off valves under the sink first before doing this. Once shut off, disconnect the hoses and check that they are clear. You will then need to check the supply hose from the valve handle control. Basically, you are trying to work your way through all of the parts of your sink faucet.